What types of fabrics are suitable for upholstered panels?
Almost any solid color fabric, unbacked or acrylic backed can be used. Heavy patterns are best suited to our Track-Tex System. Paper backed fabrics are not usable. All fabrics advertised as “Panel Fabrics” can be used as is. Acrylic backing is used to stabilize certain fabrics that tend to stretch indefinitely. Silk must always be backed. Rayon, nylon and blends of these yarns should also be backed.
What kinds of details are available?
Consult the detail heading of this section for specifics of what is possible.
What happens if fabric sags?
Due to the construction of the panels, sagging is virtually non-existent. DFB will remove the panel and re-stretch the fabric during warranty period. If the fabric is damaged the panel MAY need to be replaced. Some fabrics can not be removed from the panel without damaging the panel substrate so a new panel may be needed.
What is the maximum size of panels?
Maximum size is 48" x 120" and is limited by the fabric width, larger panels can be made using our Track-Tex System where the maximum size unlimited.
What do you do about cutouts?
Cutouts are made in the field by our installers. This includes switches, outlets and any other functions that would otherwise be hidden behind the panel.
What are the fill choices? How do I choose?
There are three choices: Dacron, Micore, and Fiberglass. Dacron is soft and has minimum acoustical properties and gives a “Puffy” surface. Micore is tackable and has very little acoustical properties. Fiberglass has very good acoustical properties but is not recommended for use as a tackable surface.
Can I get grounds built in for pictures?
Yes, a ¼" wood blocking can be set into the back of a panel.
How are the panels installed?
Panels are glued to the underlining surface. That are shimmed where necessary, to meet abutting surfaces.
Can I mix acoustical and tackable?
No. For mixed applications consider Track-TexTM panels where the fill material can be mixed.
How thick can I make the panel? What are the advantages?
Standard thickness for all panels is ¾". However, if greater sound absorbency is required for a specific application, fiberglass panels can be made up to 4” thick. Panels can also be fired out to meet abutting surfaces.
Noise Reduction Coefficient (NRC) Average sound absorption coefficient measured at four frequencies: 250, 500, 1,000, and 2.000 Hz expresses to the nearest integral, multiple of 0.05. Rates of ability of a ceiling or wall panel or other construction to absorb sound. NRC is the fraction of sound energy, averaged over all angles of direction and from low to high sound frequencies that are absorbed and note reflected. |
